- AeroCopilot
- /
- Diretivas de Aeronavegabilidade
- /
- FAA-2024-30918
FAA-2024-30918
Airworthiness Directives; The Boeing Company Airplanes
Resumo Rápido
- Número AD
- FAA-2024-30918
- Autoridade
- FAA
- Data de emissão
- 27/12/2024
- Data efetiva
- —
- Criticidade
- routine
Autoridade
Federal Aviation Administration (EUA)
Data de Publicação
27 de dezembro de 2024
Data Efetiva
Não informada
Prazo de Cumprimento
Antes do próximo voo
Resumo da Diretiva
A FAA propõe adotar uma nova Diretiva de Aeronavegabilidade (DA) para certos aviões das séries Boeing Company Modelo 777-200, -200LR, -300, -300ER e 777F. Esta DA proposta foi motivada por um relatório indicando que um avião experienciou uma anomalia do feixe de planeio (G/S) durante uma aproximação de Sistema de Pouso por Instrumento (ILS), que resultou em uma taxa de descida superior à esperada durante o segmento final de uma aproximação ILS. A tripulação de voo poderia seguir orientação enganosa do Computador de Direcionamento de Voo (F/D) após desconectar o piloto automático, sem referência às outras informações disponíveis e indicações do painel de voo. Esta DA proposta exigiria a instalação de novo software de programa operacional (OPS) do Computador de Piloto Automático e Direcionador de Voo (AFDC) e a realização de uma verificação de configuração de software. A FAA está propondo esta DA para tratar a condição insegura nestes produtos.
The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 777-200, -200LR, -300, -300ER, and 777F series airplanes. This proposed AD was prompted by a report indicating that an airplane experienced a glideslope (G/S) beam anomaly during an instrument landing system (ILS) approach, which resulted in a higher-than-expected descent rate during the final segment of an ILS approach. The flightcrew might follow misleading flight director (F/D) guidance after disconnecting the autopilot, without reference to the other available information and flight deck indications. This proposed AD would require installing new autopilot flight director computer (AFDC) operational program software (OPS) and doing a software configuration check. The FAA is proposing this AD to address the unsafe condition on these products.Texto Completo da Diretiva
Expandir texto completo (Federal Register)Texto completo (Federal Register)
Document Headings Document headings vary by document type but may contain the following: • the agency or agencies that issued and signed a document • the number of the CFR title and the number of each part the document amends, proposes to amend, or is directly related to • the agency docket number / agency internal file number • the RIN which identifies each regulatory action listed in the Unified Agenda of Federal Regulatory and Deregulatory Actions See the Document Drafting Handbook for more details. Department of Transportation Federal Aviation Administration • 14 CFR Part 39 • [Docket No. FAA-2024-2713; Project Identifier AD-2024-00328-T] • RIN 2120-AA64 AGENCY: Federal Aviation Administration (FAA), DOT. ACTION: Notice of proposed rulemaking (NPRM). SUMMARY: The FAA proposes to adopt a new airworthiness directive (AD) for certain The Boeing Company Model 777-200, -200LR, -300, -300ER, and 777F series airplanes. This proposed AD was prompted by a report indicating that an airplane experienced a glideslope (G/S) beam anomaly during an instrument landing system (ILS) approach, which resulted in a higher-than-expected descent rate during the final segment of an ILS approach. The flightcrew might follow misleading flight director (F/D) guidance after disconnecting the autopilot, without reference to the other available information and flight deck indications. This proposed AD would require installing new autopilot flight director computer (AFDC) operational program software (OPS) and doing a software configuration check. The FAA is proposing this AD to address the unsafe condition on these products. DATES: The FAA must receive comments on this proposed AD by February 25, 2025. ADDRESSES: You may send comments, using the procedures found in 14 CFR 11.43 and 11.45, by any of the following methods: • Federal eRulemaking Portal: Go to regulations.gov. Follow the instructions for submitting comments. • Fax: 202-493-2251. • Mail: U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590. • Hand Delivery: Deliver to Mail address above between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. AD Docket: You may examine the AD docket at regulations.gov under Docket No. FAA-2024-2713; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this NPRM, any comments received, and other information. The street address for Docket Operations is listed above. Material Incorporated by Reference: • For Boeing material identified in this proposed AD, contact Boeing Commercial Airplanes, Attention: Contractual & Data Services (C&DS), 2600 Westminster Blvd., MC 110-SK57, Seal Beach, CA 90740-5600; telephone 562-797-1717; websitemyboeingfleet.com. • You may view this material at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. It is also available atregulations.gov under Docket No. FAA-2024-2713. FOR FURTHER INFORMATION CONTACT: Michael Closson, Aviation Safety Engineer, FAA, 2200 South 216th St., Des Moines, WA 98198; phone: 206-231-3973; email: Michael.P.Closson@faa.gov. SUPPLEMENTARY INFORMATION: Comments Invited …
Fonte: Federal Register (federalregister.gov). Texto original em inglês. Conteúdo sanitizado por segurança.
Documentos e Referências
Monitore DAs automaticamente para sua aeronave
Cadastre sua aeronave no AeroCopilot e receba alertas por e-mail e notificação quando novas diretivas de aeronavegabilidade afetarem seu tipo de aeronave.
Dados obtidos do Federal Register (federalregister.gov). As informações são fornecidas para fins de consulta — consulte sempre a fonte oficial para fins de compliance regulatório.