2020-25844

Document Headings Document headings vary by document type but may contain the following: • the agency or agencies that issued and signed a document • the number of the CFR title and the number of each part the document amends, proposes to amend, or is directly related to • the agency docket number / agency internal file number • the RIN which identifies each regulatory action listed in the Unified Agenda of Federal Regulatory and Deregulatory Actions See the Document Drafting Handbook for more details. Department of Transportation Federal Aviation Administration • 14 CFR Part 39 • [Docket No. FAA-2020-0686; Product Identifier 2019-NM-035-AD; Amendment 39-21332; AD 2020-24-02] • RIN 2120-AA64 AGENCY: Federal Aviation Administration (FAA), DOT. ACTION: Final rule. SUMMARY: The FAA is superseding Airworthiness Directive (AD) 2018-23-51, which applied to all The Boeing Company Model 737-8 and 737-9 (737 MAX) airplanes. AD 2018-23-51 required revising certificate limitations and operating procedures of the Airplane Flight Manual (AFM) to provide the flightcrew with runaway horizontal stabilizer trim procedures to follow under certain conditions. This AD requires installing new flight control computer (FCC) software, revising the existing AFM to incorporate new and revised flightcrew procedures, installing new MAX display system (MDS) software, changing the horizontal stabilizer trim wire routing installations, completing an angle of attack (AOA) sensor system test, and performing an operational readiness flight. This AD also applies to a narrower set of airplanes than the superseded AD, and only allows operation (dispatch) of an airplane with certain inoperative systems if specific, more restrictive, provisions are incorporated into the operator's existing FAA-approved minimum equipment list (MEL). This AD was prompted by the potential for a single erroneously high AOA sensor input received by the flight control system to result in repeated airplane nose-down trim of the horizontal stabilizer. The FAA is issuing this AD to address the unsafe condition on these products. DATES: This AD is effective November 20, 2020. The Director of the Federal Register approved the incorporation by reference of a certain publications listed in this AD as of November 20, 2020. ADDRESSES: For service information identified in this final rule, contact Boeing Commercial Airplanes, Attention: Contractual & Data Services (C&DS), 2600 Westminster Blvd., MC 110-SK57, Seal Beach, CA 90740-5600; telephone 562-797-1717; internet https://www.myboeingfleet.com. You may view this service information at the FAA, Airworthiness Products Section, Operational Safety Branch, 2200 South 216th St., Des Moines, WA. For information on the availability of this material at the FAA, call 206-231-3195. It is also available on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2020-0686. Examining the AD Docket You may examine the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2020-0686; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this final rule, any comments received, and other information. The address for Docket Operations is U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590. FOR FURTHER INFORMATION CONTACT: Ian Won, Manager, Seattle ACO Branch, FAA, 2200 South 216th St., Des Moines, WA 98198; phone and fax: 206-231-3500; email: 9-FAA-SACO-AD-Inquiry@faa.gov. SUPPLEMENTARY INFORMATION: Discussion …

Fonte: Federal Register (federalregister.gov). Texto original em inglês. Conteúdo sanitizado por segurança.