- AeroCopilot
- /
- Diretivas de Aeronavegabilidade
- /
- 2020-08297
2020-08297
Airworthiness Directives; PZL Swidnik S.A. Helicopters
Resumo Rápido
- Número AD
- 2020-08297
- Autoridade
- FAA
- Data de emissão
- 20/04/2020
- Data efetiva
- 05/05/2020
- Criticidade
- routine
Autoridade
Federal Aviation Administration (EUA)
Data de Publicação
20 de abril de 2020
Data Efetiva
05 de maio de 2020
Prazo de Cumprimento
Antes do próximo voo
Resumo da Diretiva
A FAA está adotando uma nova Diretiva de Aeronavegabilidade (DA) para helicópteros Modelo PZL W-3A fabricados pela PZL Swidnik S.A. (PZL). Esta DA exige a inspeção dos parafusos e arruelas da caixa de engrenagens principal (CEP) para determinar se estão adequadamente travados e, dependendo do resultado da inspeção, remover o motor, remover determinados parafusos de serviço e realizar inspeções mais aprofundadas; e dependendo do resultado dessas inspeções, substituir o conjunto de vedação de grafite ou removê-lo de serviço. Por fim, esta DA proíbe a instalação de qualquer CEP afetada em um helicóptero, a menos que atenda aos requisitos desta DA. Esta DA foi motivada por relatos de que os parafusos que fixam o comando de entrada e o conjunto de vedação de grafite da CEP não estavam adequadamente travados. As ações desta DA destinam-se a abordar uma condição insegura nesses produtos.
The FAA is adopting a new airworthiness directive (AD) for PZL Swidnik S.A. (PZL) Model PZL W-3A helicopters. This AD requires inspecting the main gearbox (MGB) bolts and washers to determine if they are properly locked and, depending on the inspection outcome, removing the engine, removing certain bolts from service, and performing more in-depth inspections; and depending on the outcome of those inspections, replacing the graphite seal assembly or removing it from service. Finally, this AD prohibits installing any affected MGB on a helicopter unless it has met the requirements of this AD. This AD was prompted by reports that the bolts securing the input quill and graphite seal assembly of the MGB were not properly locked. The actions of this AD are intended to address an unsafe condition on these products.Texto Completo da Diretiva
Expandir texto completo (Federal Register)Texto completo (Federal Register)
Document Headings Document headings vary by document type but may contain the following: • the agency or agencies that issued and signed a document • the number of the CFR title and the number of each part the document amends, proposes to amend, or is directly related to • the agency docket number / agency internal file number • the RIN which identifies each regulatory action listed in the Unified Agenda of Federal Regulatory and Deregulatory Actions See the Document Drafting Handbook for more details. Department of Transportation Federal Aviation Administration • 14 CFR Part 39 • [Docket No. FAA-2020-0390; Product Identifier 2018-SW-096-AD; Amendment 39-19901; AD 2020-07-22] • RIN 2120-AA64 AGENCY: Federal Aviation Administration (FAA), DOT. ACTION: Final rule; request for comments. SUMMARY: The FAA is adopting a new airworthiness directive (AD) for PZL Swidnik S.A. (PZL) Model PZL W-3A helicopters. This AD requires inspecting the main gearbox (MGB) bolts and washers to determine if they are properly locked and, depending on the inspection outcome, removing the engine, removing certain bolts from ( printed page 21755) service, and performing more in-depth inspections; and depending on the outcome of those inspections, replacing the graphite seal assembly or removing it from service. Finally, this AD prohibits installing any affected MGB on a helicopter unless it has met the requirements of this AD. This AD was prompted by reports that the bolts securing the input quill and graphite seal assembly of the MGB were not properly locked. The actions of this AD are intended to address an unsafe condition on these products. DATES: This AD becomes effective May 5, 2020. The Director of the Federal Register approved the incorporation by reference of a certain document listed in this AD as of May 5, 2020. The FAA must receive comments on this AD by June 19, 2020. ADDRESSES: You may send comments by any of the following methods: • Federal eRulemaking Docket: Go to https://www.regulations.gov. Follow the online instructions for sending your comments electronically. • Fax: 202-493-2251. • Mail: Send comments to the U.S. Department of Transportation, Docket Operations, M-30, West Building Ground Floor, Room W12-140, 1200 New Jersey Avenue SE, Washington, DC 20590-0001. • Hand Delivery: Deliver to the “Mail” address between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. Examining the AD Docket You may examine the AD docket on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2020-0390; or in person at Docket Operations between 9 a.m. and 5 p.m., Monday through Friday, except Federal holidays. The AD docket contains this AD, the European Union Aviation Safety Agency (previously European Aviation Safety Agency) (EASA) AD, any incorporated by reference service information, any comments received, and other information. The street address for Docket Operations is listed above. For service information identified in this final rule, contact WSK “PZL- Świdnik” S.A., Al. Lotników Polskich 1, 21-045 Świdnik, Poland, telephone +48 664 424 798, or at www.pzl.swidnik.pl. You may review the referenced service information at the FAA, Office of the Regional Counsel, Southwest Region, 10101 Hillwood Pkwy, Room 6N-321, Fort Worth, TX 76177. It is also available on the internet at https://www.regulations.gov by searching for and locating Docket No. FAA-2020-0390. FOR FURTH…
Fonte: Federal Register (federalregister.gov). Texto original em inglês. Conteúdo sanitizado por segurança.
Documentos e Referências
Monitore DAs automaticamente para sua aeronave
Cadastre sua aeronave no AeroCopilot e receba alertas por e-mail e notificação quando novas diretivas de aeronavegabilidade afetarem seu tipo de aeronave.
Dados obtidos do Federal Register (federalregister.gov). As informações são fornecidas para fins de consulta — consulte sempre a fonte oficial para fins de compliance regulatório.